![]() ![]() Where do I set the tool plunge speed, mine takes ages to plunge into the work surface. Thanks for your help, it gave me hope to at least sit in front of the PC, and figure it all out. dnc file as before, I had it saved in a different location, and low and behold, the thing worked !! Afterwards, I went and checked every seingle set-up page, all are exactly the same values, selections, names, ALL THE SAME as before, but now it works !! I set up the Machine Axis and Steps/mm only, as well as Disabled the E-stop Terminal. When checking the version, once installed, it showed up as version 2.0.1.108, Firmware 2.24. I wiped the DeskCNC directory from my PC, and installed the file DeskCNC v2_0_1_99.Exe all over again. I did what goes against my logic, and that was to uninstall it all. Please check if you can find anything wrong. When the cut starts as a straight line, it will cut to the first change of direction, then hit this invisible limit. The error happens when going from line 10 to line 11.ĭoes the same with other files, right after lowering the z-axis, or when hitting the first corner, it hits a limit switch. I have attached my CAD file, as well as the cut file. ![]() The message on the bottom left says "Limit Switch Hit". ![]() I hit Go, it starts up, jogs the router to the first entry, lowers the Z-Axis, but when it has to start cutting, it hits some or other Limit, stops the program execution. I cancel the E-Stop by hitting Reset, all the controls now active. dnc, it goes to Machine Mode, I confirm the file is loaded, I can see the G-code in the bottom. dxf file with DeskCNC, go to Select All, go to Toolpath, select Contour, enter 2 as the Contour Depth, hit Contour, back to Toolpath, select Run Machine, save the file as a. When I open the DeskCNC application, I can jog all 3 my axis, no hassles. I'm trying to cut an extremely simple part. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |